Instruction for use for hydraulic power steering systems

1. Ceramizer® is suitable with all types of oil for power steering.
   Ceramizer® does not affect oil at all. Its viscosity and composition remain the same. Oil is used as a mean of delivery an active nano particles into the internal, metal and rubbing parts of the hydraulic power steering system.
2. Lowered dose of Ceramizer® will not give the expected results.
3. Increased dose doesn't cause any side effects, it only lengthens the process of cermet creation.
4. The ceramic layer lasts up to 2 years depending on the operating conditions of the mechanism (in normal operating conditions) or up to 100 000 km / 60 000 miles.
5. Ceramization of worn surfaces can be repeated many times with Ceramizer®.
6. Ceramizer® can be used for any devices (including industrial devices) after consulting Ceramizer®’s Producer.
   
7. This technology is intended to protect new and recondition worn but not damaged mechanisms.

1. Warm the engine to normal operating temperature by driving a few km (miles).
2. Turn the engine off.
3. Unscrew the cap oil reservoir in the power steering system and pour 1/2 of the content of the syringe to the inlet. Make sure that the require level of oil is maintained.
4. Turn the cap oil reservoir.
5. Turn the engine on. Then keep turning the steering wheel full left and full right for about 5 – 10 minutes. This should be done when the vehicle is not in motion or is going at a low speed.
6. Torn the engine on again, unscrew the cap oil reservoir in the power steering system and pour rest 1/2 of the content of the syringe to the inlet.
7. Repeat actions 4 and 5.
8. The metal-ceramic layer developes still up to 1500 km /935 miles in normal operating conditions. During this time oil exchange is not recommended.

1. If any teflon or molybdenum components had been added to oil before, we recommend to exchange this oil and to clean mechanism before appying Ceramizer® . Otherwise its effectiveness will be reduced and process of the cermet creation will be lengthened.
2. In case of any mechanical damages of the transmission e.g. broken cog, deep scratches, cracks, significant waste, etc., they should be repaired before adding Ceramizer®.
3. Ceramizer® does not recondition any places where friction of rubber or plastic with metal parts occurs.
4. The syringes are also correctly filled even if a small leakage of product under the pusher is noticed.